Terminology Overview - Barco iD PRO R600 Owner's Manual

4. Setup
Remote control functions.
This remote control includes a battery powered infrared (IR) transmitter that allows the user to control the projector remotely. This
remote control is used for source selection, control, adaptation and set up. It includes automatic storing of picture controls (Bright-
ness, Sharpness...) and settings.
Other functions of the remote control are :
• switching between stand by and operational mode.
• switching to "pause" (blanked picture, full power for immediate restarting)
• direct access to all connected sources.
Diagnose LED's
LED1
LED2
LED3
4.2

Terminology overview

Overview
The following table gives an overview of the keys.
16
Green
cool down sequence: flickers 60 seconds (120
seconds in case of iQ 400 series) after switching
to standby
only for the versions containing a server:
shows when projector is in
standby and server is active.
IR acknowledgement
Red
rescue program (software error)
hardware error
continue : standby
flickers : Security = ON
R5976874 ID PRO R600/R600+ 21/09/2006