Table of Contents
Advertisement
6. GETTING STARTED
Overview
•
RCU & Local keypad
•
Terminology overview
•
Operating the projector
•
Quick Set Up Adjustments
•
Using the RCU
•
Projector Address
•
Controlling the Projector
6.1 RCU & Local keypad
How controlling the projector ?
The projector can be controlled by the local keypad or by the remote control unit.
Location of the local keypad ?
The local keypad is located on the input side of the projector.
Remote control functions.
This remote control includes a battery powered infrared (IR) transmitter that allows the user to control the projector remotely. This
remote control is used for source selection, control, adaptation and set up. It includes automatic storing of picture controls (Bright-
ness, Sharpness...) and settings.
Other functions of the remote control are :
•
switching between stand by and operational mode.
•
switching to "pause" (blanked picture, full power for immediate restarting)
•
direct access to all connected sources.
6.2 Terminology overview
Overview
The following table gives an overview of the different functionalities of the keys.
1
Function keys
2
ADJ.
3
Address key
4
Selection key (*)
5
PAUSE
6
STBY
7
MUTE
8
?
9
Digit buttons
R5976445 BARCO GALAXY 15042003
user programmable keys with functions for direct access.
Adjust key, to enter the adjustment mode
(recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
to direct access the zoom/focus/shift functions.
to stop projection for a short time, press 'PAUSE'. The image disappears but full power is
retained for immediate restarting.
standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds until the message 'Saving data,
please wait' is displayed. Do not press any longer on the standby key otherwise
the projector will restart.
to interrupt the sound reproduction.
When running in Stereo Mode use this button to toggle the projector between Mono Mode
and Stereo Mode.
direct input selection.
6. Getting Started
27
Advertisement
Table of Contents
