Table of Contents
Advertisement
This function can be disabled if undesired or inadequate for safety reasons, etc.
C
AUTION
precautions
Make sure that the projector (or the operators!) will not be affected by altered environmental conditions when
restarting at power resume.
How to enable/disable the Automatic startup?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Automatic startup
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable/disable the automatic startup (image 4-17)
7. Press ENTER
Image 4-17
R5976874 ID PRO R600/R600+ 21/09/2006
:
If the Automatic startup function is enabled one must be aware of the fact that it involves safety
4. Setup
25
Advertisement
Table of Contents
