Table of Contents
Advertisement
7.4.4
Configuring the client software
The same universal client interface is used for different network centric projectors (iQ, iD, iCon). The layout of
the interface (position of the controls,...) is adapted after detection of the projector type. Some screenshots
may not fully coincide with the reality.
How to start up the client software ?
1. Start up the previously installed client program
The interface shows 3 tabs (upper tab control ): Control, Diagnosis and Configuration
The active sub interface is the control sub screen (image 7-7)
2. Click on the upper menubar to select the desired sub interface
Image 7-7
Control interface
IP
Internet Protocol. The network layer of TCP/IP. Required for communication with the internet.
How to add a projector to the projector list
1. Click on the white arrow (image 7-8)
A menu is dropped down (image 7-9)
2. click on the + sign of the projector list
A dialog box is displayed (image 7-10)
3. Fill in the Name, the IP address (optional) and the Port number of TCP/IP connection
Note: default port number = 9999
4. Fill in the alias
Tip:
"Alias" is a custom name whereas "Name" is the name by which the projector is identified on the (corporate) network
5. Click OK to confirm or Cancel
The projector is now added to the list of projectors
R5976874 ID PRO R600/R600+ 21/09/2006
7. IQ Network
113
Advertisement
Table of Contents
