Switching On - Barco iD PRO R600 Owner's Manual

4. Setup
13 DIGI ZOOM
14 FREEZ
15 PIP
16 ENTER
17
Cursor keys
18 BACK
19 EFFECTS
20 PIP ADJUST
21 RC operating indication
22 IR receiver
Table 4-2
ordernumber RCU: R763794K
4.3

Switching on

How to switch on.
1. Press the power switch to switch on the projector.
When '0' is pushed in, the projector is switched off.
-
- When '1' is pushed in, the projector is switched on
The projector starts in standby mode, LED3 is red.
Starting image projection.
1. Press Standby key once on the local keypad or on the remote control. (image 4-3)
M EN U
PA U SE
9
Image 4-3
It may take about 60 seconds before image projection, i.e. no projection until the completion of several oper-
ations (software initialization,...).
If the Security mode is enabled, a textbox will be displayed for PIN code entry, see Security setting in the
Installation menu
18
allows a digital Zoom of a part of the image
press to freeze the projected image.
allows to activate the PICTURE IN PICTURE mode
to confirm an adjustment or selection in the MENU.
On the local keypad the ENTER button additionally accesses the PIP window resize function
Cursor Keys on RCU or on the local keypad : to make menu selections or to access the
toolbar.
to leave the selected menu or item (go upwards to previous menu).
not yet implemented
allows to select a PiP window and change its configuration on screen
lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
IR receiver
B A C K
EN T ER
PI P
L O G O
D I G I
Z O O M
0
PH A SE
R5976874 ID PRO R600/R600+ 21/09/2006