Barco iD PRO R600 Owner's Manual page 53

Note that native resolution refers here to the source and does thus only have sense when handling data sources (greyed out for
video sources).
Depending on the type of projector the "show native resolution" function will handle the sources as follows:
Source
Name Ratio
xga
4:3
sxga
5:4
sxga+
4:3
uxga
4:3
Table 6-1
Show native resolution = ON
The Full screen representation function on the other hand forces to use the complete native resolution of the
LCD panels.
How to enable the "Show native resolution" function?
1. Press MENU to activate the Tool bar
2. Press → to select the Image item
3. Press ↓ to Pull down the Image menu
4. Use ↑ or ↓ to select Show native resolution (image 6-28)
5. Press → to pull down the menu
6. Use ↓ or ↑ to select On
7. Press ENTER
A white bullet shows the selection
Image 6-28
The default mode is used if the Show native resolution and the Full screen representation are off.
The default mode shows always the native ratio and forces the native resolution of the panels (part of the
image blanked where needed)
When show native resolution is ON and the resolution of the source is higher than the panel resolution , use
the arrow keys to scroll through the image (pan).
R5976874 ID PRO R600/R600+ 21/09/2006
Projected image
Resolution Ratio
1024x768 4:3
1280x1024 5:4
1400x1050 4:3
1600x1200 4:3
Resolution Display
1024x768 image centered +side blanked
1280x1024 image centered +side blanked
1400x1050 image centered
1600x1200 scroll image
6. Advanced
47