Ftp Upgrade Method; Table 6-2: Serial Terminal Settings - evertz 2432TX-2 Instruction Manual

2432TX-2
Dual Path Dual Link DVI to Serial Converter
6.2.

FTP UPGRADE METHOD

1. Set the IP address on the unit.
2. Connect serial port to the unit.
3. Open HyperTerminal and set the serial setting as follows:
4. Press "Enter" to access the menu.
5. Select Option 1. Network Configuration.
6. Select Option 1. Set IP address and enter the IP address. Once complete press the <enter> key.
7. Select Option 2. Set Netmask and enter the netmask. Once complete press the <enter> key.
8. Press "S" to save and exit.
9. Reboot the unit.
10. Open a command prompt on the computer where 2432TX-2 network cable is plugged.
11. Ping the 2432TX-2 to confirm it is reachable from the computer.
12. Ftp to the unit. Press enter for user name and password.
13. Type "quote site upgrade" in the command prompt and press the <enter> key.
14. Type "Put_", then drag and drop the "runtime" file. Once complete press the <enter> key (_
represent space after the Put command)
15. After the ftp is complete, the card will reboot automatically.
Page 30
Baud 115200
Parity
Data bits
Stop bits
Flow Control

Table 6-2: Serial Terminal Settings

Revision 1.0
no
8
2
None
UPGRADING FIRMWARE