Video Control - evertz 2432TX-2 Instruction Manual


Note: Output monitor is available for Output 1 and Output 2.
7.3.8.

Video Control


Note: Output monitor is available for Output 1 and Output 2.
Video Format: This option allows user to set output to be SMPTE spec or Evertz proprietary 3G-Glink
(For HDCP encrypted input output must be set to 3G-Glink).
Bandwidth: This option allows user to set output bandwidth to be 1.5Gb/s or 3Gb/s.
Interlace: This option allows user to set output to be Interlace or Progressive.
Dual Link CFG: This option allows user to set the output raster option (for dual link input where 2 SDI
output are used).
1. Odd/Even Pixels: Configure the output to send odd pixel on BNC A \ Fiber A and even pixel on
BNC B \ Fiber B.
2. Left/Right Image Halves: Configure the output to send Left half image on BNC A \ Fiber A and
Right half image on BNC B \ Fiber B.
3. Top/Bottom Image Halves: Configure the output to send Top half image on BNC A \ Fiber A
and bottom half image on BNC B \ Fiber B.
No Signal CFG: This option allows user to set the output raster color to be Gray, Black or Green when no
input is present.
VISTALINK PRO
®
Figure 7-16: Video Control Menu
Revision 1.0
Dual Path Dual Link DVI to Serial Converter
2432TX-2
Page 43