Status Leds; User Controls; Dip Switches; Figure 4-1: 2432Tx-2 Status Leds - evertz 2432TX-2 Instruction Manual

4.

STATUS LEDS

The location of the status indicators are shown in below Figure 4-1.
PWR: When ON this LED indicates that the 2432TX-2 is receiving Power.
ERR: When Err/Fault LED is ON indicates that there is a problem with the unit.
1 When On this LED indicates that the 2432TX-2 is outputting a signal on Input 1A.
2 When On this LED indicates that the 2432TX-2 is outputting a signal on Input 2A.
3 When On this LED indicates that the 2432TX-2 is outputting a signal on Input 1B.
4 When On this LED indicates that the 2432TX-2 is outputting a signal on Input 2B.
4.1.

USER CONTROLS

4.1.1.

Dip Switches


Note: DIP Switch settings are only valid with Version 1.X.X firmware. With firmware
version 2.X.X DIP switches are inactive due to functions being moved to serial menu
and SNMP for control.
DIP Switch
1 Output format: DOWN=SDI, UP=3G-GLink
Changes output bandwidth: DOWN=3G, UP=1.5G (effectively selects between 1080p
2
60 and 30)
3 Interlace Output: DOWN= Progressive Output, UP=Interlaced Output
4 Genlock: DOWN=Disable, UP=Enable
5&6 Output Frame Rate: [DOWN,DOWN]=59.94fps [UP,DOWN]=60fps [DOWN,UP]=50fps
7 Under Development, Leave Down
8 Under Development, Leave Down
STATUS LEDS

Figure 4-1: 2432TX-2 Status LEDs

Function

Table 4-1: DIP Switch Functions

Revision 1.0
Dual Path Dual Link DVI to Serial Converter
2432TX-2
Page 9