Servicing & Parts Replacement; To Replace Radiant(S); To Remove The Fascia - Valor Brava 347 Installation And Owner's Manual

11. SERVICING & PARTS REPLACEMENT
- Always turn off the gas supply and allow the appliance to cool completely
before commencing any servicing (The appliance inlet "T" connector
incorporates an isolating valve).
- It is recommended that, at least once a year, the appliance is disconnected
and the catchment space behind the closure plate checked and cleared of
any debris. The closure plate must be resealed to the wall after checking.
- Check that soot or debris is not impairing the electrode spark or pilot burner.
- Check that soot or debris is not blocking any of the holes in the main burner.
- Always test for gas soundness and spillage after servicing the appliance.
Note: For models fitted with electronic ignition it is adviseable to remove the
battery from the electronic spark generator before continuing to service the
appliance. This will prevent accidental operation of the ignition system.

11.1 To replace radiant(s).

1. Remove the dress guard by gently pulling it in the centre with one hand, and
carefully springing out one end from the fascia with the other. Slide the opposite side
of the dress guard clear of the fixing holes. Take care not to scratch the trim (See
figure 18).
2. Remove the old radiant(s). Fit the
new radiant(s) ensuring that their rear
face rests against the horizontal ribs
in the rear panel. There will be a
small gap between their bottom front
edges and the retaining channel at
the front of the radiant box.
3. Replace the dress guard.

11.2 To remove the fascia.

1. Remove the control knob by
pulling clear of the gas tap spindle.
2. Remove the two fascia retaining
screws located at the rear of the
fascia near the bottom corners. Note
from which holes the screws are
removed.
3. Lift the fascia up and forward to
clear the rear top location.
4. Replace in the reverse order. Make sure that the top rear of the of the fascia
locates fully into the 'U' shaped notch of the engine back panel (See figure 16). Make
sure that the radiants are not dislodged when refitting the fascia.
©
GDC Group Ltd. OCT 2016
INSTALLER GUIDE
Figure 18.
Page 29