Checking The Aeration Setting Of The Burner; To Remove The Window Panel; To Remove The Fuel Effect; To Remove The Ceramic Side Walls - Valor 762 Installer And Owner Manual

18.1 Checking the aeration setting of the burner.

1. The aeration shutter is factory set. It is important to ensure
that the aeration setting is correct (See figure 28).
2. If the setting is not as shown in figure 28 adjust the aeration
setting. To do this loosen the two aeration shutter screws,
slide the aeration shutter to the desired position and tighten
the screws.

18.2 To remove the window panel.

1. The window panel is secured at the bottom with two
clamps. To release the clamps, hold at the
rear and pull down
(See figure 29).
2. With both clamps released, gently pull the
base of the window panel forward. Hold the
window panel base and lift upward until clear
of the two upper window retainers
(See figure 30).
3. Replace in the reverse order.

18.3 To remove the fuel effect.

1. Remove the fuel effect in the reverse order
to that shown for fitting in the ceramic guide. The ceramic fuel effect may cause
staining / discolouration to decorative surfaces. It is therefore advisable to protect
decorative surfaces.
2. Replace in the reverse order.

18.4 To remove the ceramic side walls.

1. Support the upper port cover, then unscrew and
remove the three securing screws (See figure 26).
Gently remove the port cover ensuring that the
side ceramic side walls are not scratched.
2. Gently lower the top of the ceramic side wall
towards the burner being careful not to catch the
bottom on the burner brackets. Lift the side walls
clear of the convection box.
3. Replace in the reverse order.
©
GDC Group Ltd. 2013
INSTALLER GUIDE
Page 36
Figure 28. Aeration
shutter setting.
Figure 29. Window panel Clamp
Figure 30. Window removal