Table of Contents
Advertisement
INSTALLER GUIDE
10. CONVECTION BOX INSTALLATION
10.1 Method 1 - Front fixing to fireplace surround.
1. Make sure that the fireplace front surround area is
sound enough to take the fibre / wooden plugs and
woodscrews. If necessary, make sound with suitable
cement.
2. Place the convection box centrally in the fireplace
in the position in which it is to be permanently
installed. If a concealed connection is being used,
insert the convection box into the fireplace feeding
the supply pipe through the pierced hole in the rear
grommet.
3. Mark the fireplace front surround through the four
fixing holes in the side flanges of the convection box
(See figure 16).
4. Remove the convection box. Drill four holes in the
Figure 16. Front fixing
fireplace front surround at the
marked positions using a
suitably sized masonry drill for
the fibre / wooden plugs
supplied.
5. Insert a fibre / wooden plug
into each hole.
6. Place the convection box
back in position in the
fireplace.
7. Fit a woodscrew through
each hole in the convection
box flanges and tighten to seal
Figure 17. Eyebolt positions
the box to the fireplace
surround.
10.2 Method 2 - Cable retention and floor fixing.
1. Make sure that the relevant areas at the fireplace back or floor are sound enough
to take the eyebolts and screws. If these areas have deteriorated due to prolonged
use they should be made sound with suitable cement.
2. Drill four holes in the rear wall of the fireplace for the eyebolt plugs. The holes
should be drilled within the range of positions shown in figure 17 using a suitably
sized masonry drill for the fibre / wooden plugs supplied. The holes should be
equidistant each side of the centre line of the fireplace to ensure that the appliance
finishes centrally in the opening when tension is applied to the cables.
3. Insert a fibre / wooden plug into each hole. Use the fibre / wooden plugs supplied
©
Baxi Heating U.K. Limited 2008.
Page 23
Hide quick links:
Advertisement
Chapters
Table of Contents
