To Remove The Trim; To Remove The Visual Baffle; To Remove The Window Door Panel; To Remove The Fuel Effect And Ember Wool - Valor 500FS Installer And Owner Manual

INSTALLER GUIDE

18.1 To remove the trim.

1. The trim is held in place with four magnets one
placed into each corner. Hold the lower outside
edges of the trim and gently pull forward. With the
corners released, lift the trim away from the
convection box and clear.

18.2 To remove the visual baffle.

1. Complete section 19.1
2. Remove the visual baffle, by unscrewing by hand
the two M5 knurled screws in an anti clockwise
direction. Keep these two screws save as they will be
needed later. Carefully slide out the decorative trim
and place carefully to one side.
3. Replace in the reverse order.

18.3 To remove the window door panel.

1. Complete section 19.2
2. Remove the glass door, by unscrewing by hand the
two M5 knurled screws in an anti clockwise direction
located just under the base of the door frame. Keep
these two screws save as they will be needed later.
Carefully pully out at the base then lift up and off the
door and place carefully to one side.
4. Replace in the reverse order.

18.4 To remove the fuel effect and ember wool.

1. Complete sections 19.1 - 19.3
2. Remove the fuel effect in the reverse order to that shown for fitting in the ceramic
guide. The ceramic fuel effect may cause staining / discolouration to decorative
surfaces. It is therefore advisable to protect decorative surfaces.
The ember wool is positioned across the burner carefully lift up all the steel wool and
place carefully to one side. Refer to the installation instructions earlier regarding
placing this ember wool back onto the burner.
3. Replace both in the reverse order.
© Page 39
GDC Group Ltd. SEPT 2016