Cleaning Your Fire - Valor 961 Installation And Owner's Manual

Inset live fuel effect gas fire incorporating the fireslide control fitted with one of the following fascia: aurora, solaris or lunar

Hide thumbs

Table of Contents

To maintain the high performance and quality finish of your fire please follow these

guidelines:

Before attempting to clean the fire, please remember to turn off the fire and wait for

the appliance to cool. The fire will retain heat for some time before cleaning can

begin.

If any pieces of debris are found in the firebox, have the chimney inspected before

further use.

Glass and Metal parts.

Clean the glass and metal parts with a slightly damp cloth and then dry.

Do not use abrasive cleaners as these will scratch the fire surface.

Window assembly.

Removing and cleaning the window assembly.

Removal of the window assembly is only necessary if you wish to clean the rear of the

window or access the ceramic components. The window assembly can be cleaned

with a mild detergent and water. Glass cleaner can also be used. Any stains on the

glass can be removed with a non-abrasive cleaner such as a ceramic hob cleaner.

Never use abrasive cleaners. Clean the window carefully in accordance with the

instructions supplied with the cleaner.

Note:

When removing and fitting the window assembly care must be taken to ensure

that the bottom of the glass is lifted high enough to clear the front ceramics and

prevent damage to them. Ensure that the

inside face of the window assembly is

clean and free of fingerprints.

1. The window assembly is held in place

with two clamping brackets that rotate

around a central pivot point. Push the

brackets up and clear of the window

assembly (See figure 4). Gently pull the top

of the window frame forward and lift the

window assembly clear of its support

channels (See figure 5). Place the window

assembly in a safe place away from the

work area.

2. Replace in the reverse order.

Baxi Heating U.K. Limited 2008.

OWNER GUIDE