Heat Settings; To Remove The Glass Door - Valor 474 Valentia Installation And Owner's Manual

OWNER GUIDE
Turn the control knob to setting 1 before choosing any other.
NOTE: The control knob should be pushed in slightly before turning, and always set
to one of the stated positions.
It is connected to the gas tap by a universal coupling and will have a 'loose feel' to it,
which should not cause concern.warms up, as explained above, then release it. If the
pilot does not remain alight turn the knob back to OFF, wait a few seconds and repeat
the lighting sequence.
To turn off
Push in the control knob slightly and turn it clockwise to OFF position.
WARNING: If you want to relight a hot fire wait three minutes before doing so.
FIG 1B

Heat Settings

There are four heat settings 1, HIGH, 2 and ECON (See Fig. 1A). Setting 1 provides
gas to the full burner at a low level. Setting HIGH gives the full heat output. Setting 2
uses about the same amount of gas as 1 but limits this to the centre section of the
burner. You therefore see a different flame picture but still see the pilot flame on the
right. Setting ECON is the lowest heat setting and gives gas at a low rate to the
centre burner section. Never turn the knob quickly from pilot to 2 or ECON, always
turn to 1 first.

TO REMOVE THE GLASS DOOR

Pull the door mask upwards and forwards (see fig 1B). The glass door is retained by
ten wing nuts and after removing these you may slide the glass door forwards and
away from the fire. The inside of the window should be cleaned with a 'ceramic hob'
cleaner, such as Hobbrite, before refitting
©
GDC Group Ltd. 2014
Page 29