Pack Contents - Valor 961 Installation And Owner's Manual

The items required for this appliance are packed in sections.
Section 1 - Fire unit contains:
1 Burner and convection box unit.
1 Burner tray trim (Supplied in separate pack).
1 Outlet baffle for the convected air outlet
2 Tapping Screws for outlet baffle.
1 Nut and olive for 8mm inlet pipe.
1 'T' connector and pressure test point.
1 Flue restrictor plate.
3 Tapping Screws (For flue restrictor).
2 Small "U" seals (For convection box side flanges).
1 Strip of floor sealing tape.
6 Fibre / wooden plugs.
4 Woodscrews.
2 Fire retaining cables.
2 Cable clamps.
4 Eyebolts.
1 Rubber grommet (For rear of convector box).
2 Machine screws (For fascia hanging).
2 Washers for fascia hanging.
1 PP3 Battery.
1 Smoke match tube.
2 Fireback spacing brackets.
4 Tapping Screws (For fireback spacing brackets).
1 Length of self adhesive foam seal.
1 Literature pack.
1 Ceramic fuel effect set.
4 Tapping screws for fascia hood.
1 Slider control position label
Section 2 - fascia pack contains:
1 Fascia and ash pan casting.
Carefully remove all the contents. Take special care in handling the ceramic pieces.
Take care not to bend or distort the slide control linkage when handling the fascia.
Check that all the listed parts are present and in good condition.
©
Baxi Heating U.K. Limited 2008.
INSTALLER GUIDE

5. PACK CONTENTS

Page 16