Final Review - Valor 961 Installation And Owner's Manual

INSTALLER GUIDE

16. FINAL REVIEW

1. COMPLETE THE INFORMATION IN THE WARRANTY AND SERVICE SECTION
OF THE OWNER GUIDE (See last pages of the OWNER guide).
2. Visually inspect the appliance. Clean off any marks incurred during installation.
3. Advise the customer how to operate the appliance. Point out that lighting instruction
details are on the metal plate attached at the bottom of the appliance. Explain to the
customer that the appliance has a flame failure & spillage monitoring system. Point
out the explanation of this system shown in the owner guide under "Operating the
fire". Advise that if the fire goes out for any reason, wait at least three minutes before
relighting. Stress that if the monitoring system repeatedly shuts off the fire, the
appliance should be switched off and a specialist should be consulted.
4. Advise the customer that they should read their owner guide before operating the
fire and always follow the advice in the section headed "Cleaning your fire".
5. Stress that no extra ceramic fuel effect pieces must be added over and above
those supplied with the appliance and that any replacements must only be the
authorised spares. Warn that ignoring this advice could cause incomplete
clearance of the products of combustion with consequent health hazards. If you
have not done so already; attach or place the ceramic fuel effect guide inside
this guide.
6. Advise the customer that the appliance will operate to its maximum potential if the
flue is primed during the first 20 – 30 minutes of use. To do this, simply slide the
control to its highest setting. This will also burn off any carbon deposits that may have
formed during previous use.
7. Emphasise that if the window assembly is broken or damaged, the fire should
be turned off and not used until the window unit is refitted with an authorised
replacement. The fire should not be used without the window assembly fitted.
8. Advise the customer that when first turned on from cold, the flames will appear
predominantly blue and it is normal for condensation to form on the rear of the
window assembly. The condensation will disappear after a few minutes use.
9. If using the appliance for long periods it is beneficial to change between settings.
This will also help to remove any carbon deposits that may form during use.
10. Recommend that the appliance should be serviced by a competent person at least
annually.
11. If the appliance is in premises in the United Kingdom occupied by a tenant, point
out that by law a landlord must have any gas appliance, flue and pipework which is
situated in a tenant's premises checked for safety at least every 12 months.
12. Advise that the fire may give off a slight odour while new. This is quite normal and
it will disappear after a short period of use.
13. Inform the customer that the serial number for the appliance is located on
the information label, located behind the lower front casting and underneath the
burner module.
14. Hand the literature pack with this guide to the customer.
©
Baxi Heating U.K. Limited 2008.
Page 32