Table of Contents
Advertisement
Installation
Decorative Glass Murano 1500DGM
Material required
• Steel platform (supplied with appliance)
• Decorative Glass Murano Glass kit, which contains:
• 1 glass platform
• 1 bag of clear 1/2" fi reglass
Installation
Carefully unpack the kit.
1. Install the steel platform around the burner as
indicated. The openings in the platform should be
underneath. The edge of the burner protrudes
above the platform.
Installed platform
2. Install the glass plate on the platform, the textured
side underneath and the smooth side on top. The
plate is fl ush with the edge of the burner.
Installed glass plate
46
3. Carefully spread the fi reglass on the surface of
burner patting it gently with your hand to form a
single layer to the approximate level of the top edge
of the fl ange around the burner. Do not place too
much to avoid blocking the burner ports.
4. Some fi reglass may be added on the platform to
cover the edge of the burner and in the space in
front and behind the pilot shield.
NOTE: Ensure the area within the pilot shield is clear
of fi reglass.
Pilot shield
IMPORTANT: Approved for use only with the fi reglass
provided with your Valor fi replace or the tempered
crushed fi reglass brands American Fireglass™ or
fi regear. The use of any other fi reglass products may
void your fi replace warranty.
WARNING
Choking Hazard! Ensure that the fireplace
area is clear of fireglass particles as these
could be ingested by small children.
Vacuum area after installation.
Fuel Beds
Advertisement
Table of Contents
