Rear Panel - Sony PDW-HD1200 Operation Manual

Rear Panel

1 Power supply section (see
page 25)
2 Analog audio signal input/
output section (see
page 25)
1 HDMI OUT connector
2 SD/HDSDI INPUT connector
(i.LINK) S400 connector
3
4 HDSDI OUTPUT 1, 2
(SUPER) connectors
5 SDSDI OUTPUT1, 2 (SUPER) connectors
6 REMOTE(9P) connector
a HDMI OUT connector
Connects to an HD projector, HD television, or other HD
consumer device, and outputs digital signals (video, audio,
and control signals).
The audio signals of the channels selected with MONITR
L and MONITR R in the P2 AUDIO page of the function
menu are output.
See "Basic Operations of the Function Menu" (page 43)
for more information.
b SD/HDSDI INPUT (SDSDI/HDSDI signal input)
connector (BNC type)
This inputs an SDSDI or HDSDI format video/audio
signal.
c
(i.LINK) S400 connector (6-pin, IEEE1394
compliant)
Connect a computer or other device, using an i.LINK
cable.
Notes
• When this unit is connected to a device with a 6-pin
i.LINK connector by an i.LINK cable, before
unplugging the i.LINK cable, first power off the device
and disconnect the power plug from the outlet. If the
i.LINK cable is unplugged with the device power plug
still connected, a current from an excessive voltage (8 to
40 V) output from the i.LINK connector of the device
flows into this unit. This may cause a failure of the unit.
24
Rear Panel
• When connecting this unit to a device with a 6-pin
i.LINK connector, connect to the 6-pin i.LINK
connector of the other device first.
d HDSDI OUTPUT 1, 2 (SUPER) (HDSDI signal
output 1, 2 (superimpose)) connectors (BNC type)
These output HDSDI format video/audio signals.
You can superimpose timecodes, menu settings, error
messages, or other information on the output of the HDSDI
OUTPUT 2 (SUPER) connector with the setting for
CHAR SEL on the HOME page of the function menu or
with the setting for setup menu item 028 HD
CHARACTER. You can always disable to superimpose
the data independent of the setting for CHAR SEL with the
setting for setup menu item 028.
See "Basic Operations of the Function Menu" (page 43)
for more information about the CHAR SEL settings.
See page 117 for more information about the setup menu
item 028 HD CHARACTER.
To treat the input and output signals of these connectors as
non-audio signals, set the maintenance menu item M37:
AUDIO CONFIG >M372: NON-AUDIO INPUT
(recording) (see page 136) and setup menu item 823 NON-
AUDIO FLAG PB (playback).
e SDSDI OUTPUT 1, 2 (SUPER) (SDI signal outputs
1, 2 (superimpose)) connectors (BNC type)
These output SDSDI format video/audio signals.
7 DC IN 12V connector
8 REMOTE connector
9 COMPOSITE OUTPUT1, 2
(SUPER) connectors
0 REF.VIDEO INPUT
connectors
3 Timecode input/output
section (see page 26)
(network) connector
qa
qs MAINTENANCE connectors