Sony PDW-HD1200 Operation Manual page 132

Item number Item name
932 H CROP POSITION (DC)
934 CROSS COLOR (DC)
935 DETAIL GAIN (DC)
936 LIMITER (DC)
937 CRISP (DC)
938 LEVEL DEPEND THRESHOLD (DC) Adjust the down-converter image enhancer. Set the luminance range for
939 H DETAIL FREQUENCY (DC)
940 H/V RATIO (DC)
942 V-FILTER SELECT (DC)
943 CROSS COLOR CRISP (DC)
944 D/C LEGALIZE (DC)
950 UP CONVERTER MODE
951 H CROP POSITION (UC)
952 LETTER BOX POSITION (UC)
953 UP CONVERTER PROCESS (UC)
954 DETAIL GAIN (UC)
955 LIMITER (UC)
132
Setup Menu
Menu items in the 900s, relating to digital process
Settings
Adjust the H-crop (the horizontal position when cropping in the edge crop
mode) of the down converter output when menu item 930 is set to
"EDGE CROP".
–120 to 0 to 120
Adjust the down-converter cross color.
0 to 8 to 15
Adjust the down-converter image enhancer, the sharpness of edge
enhancement.
0 to 7FH
Adjust the down-converter image enhancer, the maximum detail level
added to emphasize the original signal.
0 to 20H to 3FH
Adjust the down-converter image enhancer, the threshold amplitude at
which low amplitude signals are not emphasized.
0 to FH
edge enhancement.
0 to 8 to FH
Adjust the down-converter image enhancer. Set the central frequency for
edge enhancement.
2.6MHz, 3.4MHz, 3.9MHz, 4.6MHz
Adjust the down-converter image enhancer. Set the horizontal/vertical
ratio for edge enhancement.
0 to 3 to 7
Set the vertical interpolation filter coefficient for down-converter output (in
1080 mode only).
If the setting value is large, the vertical resolution is high.
1 to 3
Set the cross color crisp level for down-converter output.
0 to 4 to FH
For down converter output, selects whether to suppress signals with
levels that are lower than the pedestal level.
off: Do not suppress signals lower than the pedestal level.
on: Suppress signals lower than the pedestal level.
Select the up-converter mode.
CROP (EDGE CROP): Select the edge-crop mode.
L-BOX (LETTER BOX): Select the letter box mode.
SQUEZ (SQUEEZE): Select the squeeze mode.
Adjust the H-crop (the horizontal position when cropping in the edge crop
mode) of the up converter output when menu item 950 is set to "EDGE
CROP".
–120 to 0 to 120
When menu item 950 is set to "LETTER BOX", adjust the vertical location
of the position where the picture is cut out for up converter output in letter
box mode.
–120 to 0 to 120
Select the source picture to use in converting SD to HD.
FIELD: Use field pictures.
ADAPT (ADAPTIVE): Frame or field is selected automatically.
Adjust the up-converter image enhancer, the sharpness of edge
enhancement.
0 to 40H to 7FH
Adjust the up-converter image enhancer, the maximum detail level added
to emphasize the original signal.
0 to 20H to 3FH