Sony PDW-HD1200 Operation Manual page 117

Item number Item name
016 ALARM DISPLAY
017 SUB STATUS DISPLAY SELECT Determine the kind of sub status information to be output from the
024 MENU CHARACTER TYPE
028 HD CHARACTER
029 STORED OWNERSHIP
031 RECORDING FORMAT
033 BATTERY END VOLTAGE
Settings
Select whether to display alarm messages.
off: Do not display alarm messages. (However, certain important alarms are
displayed.)
limit (on (limited)): Display only a minimum number of alarm messages.
on: Display all alarm messages.
For details about alarm message display conditions, see "Alarms"
(page 147).
COMPOSITE OUTPUT 2 (SUPER) connector, SDSDI OUTPUT 2 (SUPER)
connector, HDSDI OUTPUT 2 (SUPER) connector, or HDMI OUTconnector.
off: Do not output sub status information.
rmain (disc remain): Available disc space (unit: minute)
clip (clip no): Order of playback of the selected clip/total number of clips
pbr (playback remain): The remaining playback time of the selected clip
from the current playback position (hours:minutes:seconds:frames).
name (clip name/title): The name of the clip that is currently being recorded
or played, as set in Settings >Display Title of the Disc Menu (standard
name, user-defined name, title, or planning metadata name)
The following characters can be displayed as clip names in this area.
• Digits: 0 to 9
• Alphabetic characters: a to z, A to Z
• The following symbols: !, ", #, $, %, &, ', (, ), *, +, , (comma), -, .
(period), /, : (colon), ; (semicolon), <, =, >, ?, @, [, ], ^, _, {, |, }, ~
• Space
Note
When menu item 005 is set to "off", sub status information is not displayed
when this item is set to anything other than "off".
Determine the type of characters in menu text output from the COMPOSITE
OUTPUT 2 (SUPER) connector, SDSDI OUTPUT 2 (SUPER) connector,
HDSDI OUTPUT 2 (SUPER) connector, or HDMI OUT connector for
superimposed display on the monitor.
white: White letters on a black background.
black: Black letters on a white background.
W/out: White letters with black outline.
B/out: Black letters with white outline.
Set this item by selecting the required type while viewing the monitor.
Specify whether to superimpose text information on the video signal output
from the HDSDI OUTPUT 2 (SUPER) connector.
off: Do not superimpose.
f-key (function key select): Follow the function menu setting.
Specify whether to enable changing UMID ownership information settings
(COUNTRY, ORGANIZATION and USER).
off: Do not enable.
on: Enable.
See "Using UMID Data" (page 160) for more information about UMID.
Set the recording format.
HD422: HD422
420HQ (HD420HQ): HD420HQ
420SP (HD420SP): HD420SP
IMX50 (IMX50Mbps): MPEG IMX 50 Mbps
IMX40 (IMX40Mbps): MPEG IMX 40 Mbps
IMX30 (IMX30Mbps): MPEG IMX 30 Mbps
DVCAM: DVCAM
Sets the voltage to shut down the unit in the battery operation. The battery
near end indicator flashes at +0.7 V of the set voltage.
10.5V to 13.5V: 10.5 V to 13.5 V in 0.5 V unit.
117
Setup Menu