Sony PDW-HD1200 Operation Manual page 154

Alarm message in GUI
screen
Syntax Error!
Irregular Disc is Used.
Use Professional Disc.
The Disc Write Protect TAB
is set to Save.
The REC Inhibit Mode is
Selected.
Check Function Menu.
Auto Formatting was not
Completed.
Video Resolution Differ from
it on Clip List.
No Clip Meets the Condition. This appears when no clip is found to meet clip filtering conditions.
Alarms relating to audio and video signals
Alarm message in time
data display area
a)
No INPUT!
a)
EMPHASIS!
REF NON-STD
a) Displayed only when setup menu item 016 ALARM DISPLAY is set to
"on".
Alarms relating to sensors and drives
Alarm message in time
data display area
FAN Stopped
DR-FAN Stop
High TEMP!
BATT EMPTY!
Unknown USB
Alarms related to system frequency and recording format
The following alarms are displayed only when setup menu
item 016 ALARM DISPLAY is set to "on" or "limit".
154
Troubleshooting
Description/action
This appears when loading of planning metadata fails because of a syntax error. Correct the
syntax error and try loading the metadata again.
This appears when the unit is unable to record or play the inserted disc.
This unit can record and play Professional Discs. Insert a Professional Disc.
This appears when an attempt is made to format a write-protected disc.
Try formatting the disc after moving the write protect tab away from the Save position.
This appears when an attempt was made to format when function menu item HOME >F3: REC
INH is set to "ON".
Set F3: REC INH to "OFF" and try formatting again.
This appears when auto formatting fails.
This appears when an attempt is made to add a clip to a clip list containing clips with a different
video resolution (number of system lines).
It is not possible to add clips to clip lists containing clips with a different video resolution.
Alarm message in video monitor screen Action
INPUT VIDEO IS NOT DETECTED.
CHECK THE VIDEO INPUT MODE AND
SUPPLY A VIDEO SIGNAL TO VIDEO
INPUT.
INPUT AUDIO EMPHASIS IS NOT
SUPPORTED.
CHECK THE EMPHASIS OF THE AUDIO
INPUT SIGNAL.
A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO. USE A
STANDARD SIGNAL.
Alarm message in video monitor screen Action
FAN MOTOR STOPPED.
DRIVE FAN MOTOR STOPPED.
HIGH TEMPERATURE.
HIGH TEMPERATURE IN DRIVE.
BATTERY EMPTY!
UNKNOWN USB DEVICE.
• Check the setting of V INPUT on Page P1 VIDEO of
the function menu (see page 44).
• Input an HDSDI signal.
Check the emphasis of the audio input signal.
Input a standard signal.
Contact your Sony service representative.
Note
The unit will not stop operating, but if you continue to
use it in this state temperatures inside the unit or the
drive will rise, possibly resulting in failure or fire.
Change the battery.
The USB connector of this unit is for maintenance
purposes and connection of USB devices. Connect a
compatible USB device.