Sony PDW-HD1200 Operation Manual page 129

Item number Item name
716 CHROMA GAIN CONTROL
717 CHROMA PHASE CONTROL
718 SETUP LEVEL (59.94i mode)/
BLACK LEVEL (50i mode)
719 SYSTEM PHASE SYNC
720 SYSTEM PHASE SC
723 INPUT VIDEO BLANK
Sub-Item
1 ALL LINE
2...10 LINE 12
...
LINE 20
2...15 LINE 9
...
LINE 22
726 H BLANKING WIDTH
728 OUTPUT SCH PHASE
731 WIDE MODE
Sub-Item
1 INPUT
2 OUTPUT
Menu items in the 700s, relating to video control
Settings
Adjust the chroma output level.
–2048 to 0 to 848
Adjust the chroma phase.
–128 to 0 to 127
Adjust the setup level (black level).
–272 to 0 to 272
Adjust the output signal sync phase.
–128 to 0 to 127
Adjust the output signal subcarrier phase.
0 to 511
Switch blanking on or off for lines in the vertical blanking interval of input
video signals. Lines can be specified individually. Y/C signals and odd/
even fields are blanked simultaneously.
Blanking in recorded signals is carried out according to these settings.
- - -: Specify the blanking for each line separately.
blnk (blank): Regardless of the settings of other sub-items, blank all lines
which can be specified in this menu item.
thru (throu): Regardless of the settings of other sub-items, switch
blanking off for all lines which can be specified in this menu item.
In 59.94i mode Specify blanking for lines 12 to 20.
blnk (blank): Switch blanking on.
thru (throu): Switch blanking off.
In 50i mode Specify blanking for lines 9, 322 to 22, and 335.
blnk (blank): Switch blanking on.
thru (throu): Switch blanking off.
Select the horizontal blanking width of the output analog video signal.
narow (narrow): Digital blanking (narrow)
wide: Analog blanking (wide)
When "wide" is selected, the horizontal blanking width complies with
SMPTE170M, and normally the blanking is widened and the image
becomes narrower. It is recommended to select "narow" at the editing
stage, then later, for broadcast transmission to select "wide", to output a
signal conforming to the standard. Note, however, that "narow" has to be
always selected for SDI signals.
Set the subcarrier H phase.
–512 (–512 (DEC)) to 0 (0 (DEC)) to 511 (511 (DEC))
Specify whether to record and play back with the addition of wide picture
information.
Select whether to save wide picture information to the disc when
recording.
auto: Automatically save wide picture information when it is detected in
the selected input video signal.
on: Always save wide picture information.
off: Never save wide picture information.
Select whether to add wide picture information to the signal output when
down-converter output is set to squeeze mode.
thru (through): Do not add.
auto: Add.
Notes
• To add wide picture information to the output signal, another setting is
required in addition to this item. In setup menu item 703, set line 20 (in
59.94i mode) or line 23 (in 50i mode) to "thru".
• In 59.94i mode, output of wide picture information is given priority if the
VITC insertion line is set to line 20 in setup menu item 601 or 602.
129
Setup Menu