Connections And Settings; Connections For Using The Supplied Application Software - Sony PDW-HD1200 Operation Manual

Connections and
Settings
Note
Production of some of the peripherals and related devices
described in this chapter has been discontinued.
For advice about choosing devices, please contact your
Sony dealer or a Sony sales representative.
Connections for using the supplied
application software
For an overview and installation of the application
software, see the PDF file on the supplied CD-ROM. For
information about how to use the software, refer to the
Help provided in the software.
Using the (network) connector (FTP
connection)
The following shows an example of an FTP (File Transfer
Protocol) connection.
Note
The PDW-HD1200 IP address and other network-related
settings are required for connection.
For details of the network-related settings, see "To change
network settings" (page 140).
Connecting this unit directly to a laptop computer
PDW-HD1200 (this
unit)
To (network) connector
Network cable (not supplied)
Settings on this unit
Remote control switch: NET (see page 15)
Setup menu item 257 NETWORK ENABLE: net
Connecting three PDW-HD1200 units to a laptop
computer via a LAN
CAUTION
When you connect the Network cable of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.
Settings on all PDW-HD1200
Remote control switch: NET (see page 15)
Setup menu item 257 NETWORK ENABLE: net
Using the (i.LINK) S400 connector (FAM
connection)
The following shows an example of a FAM (file access
mode) connection.
Note
The FAM driver must be installed in advance.
Laptop computer
See "Preparations" (page 104, 106) for more information
about installing the FAM driver.
Some limitations apply to FAM connections. For details,
see "File Operations in File Access Mode (for Windows)"
(page 104).
PDW-HD1200
LAN
To (network)
connector
Laptop computer
Network cable
(not supplied)
31

Connections and Settings