Sony PDW-HD1200 Operation Manual page 125

Item number Item name
344 ASSEMBLE AUTO EDIT
POSTROLL RECORDING
Item number Item name
401 FUNCTION MODE AFTER CUE-UP Select the state that the unit goes into after a cuing-up operation.
Item number Item name
501 STILL TIMER
Menu items in the 600s, relating to the timecode, metadata, and UMID
Item number Item name
601 VITC POSITION
SEL-1
Menu items in the 300s, relating to editing operations
Settings
Set whether to record 2 seconds of postroll when an additional clip is
recorded by sending the AUTO EDIT command (9-pin protocol 20·42)
from a nonlinear editing system connected to the REMOTE(9P)
connector on the rear panel.
Note
Linear editing systems follow the settings made on the linear editing
systems.
off: Do not record postroll.
on: Records approximately 2 seconds of postroll.
Menu items in the 400s, relating to preroll
Settings
stop: Stops (the stop mode).
still: Still playback (in jog and shuttle mode).
Menu items in the 500s, relating to disc protection
Settings
To protect the disc against shock and vibrations, and to lengthen the life
of the laser diodes, the unit automatically enters standby off mode
whenever a specified time elapses in a disc stop mode (stop mode or the
still picture mode of search mode). This allows you to set the time after
which the unit exits a disc stop mode and enters standby off mode.
0.5 s (0.5 sec)... 8 m (8 min)... 30 m (30 min): Can be set in the range
from 0.5 seconds to 30 minutes.
off: Do not put into standby off mode.
Settings
In 59.94i mode Select the line into which to insert VITC signals (SD output)
12H ... 16H ... 20H: Any line from line 12 through line 20.
Notes
• You can insert VITC signals in two places. To insert in two places, set
both item 601 and item 602.
• In 59.94i mode, output of wide picture information is given priority if
OUTPUT in setup menu item 731 is set to "auto" and the VITC insertion
line is set to line 20.
In 50i mode Select the line into which to insert VITC signals (SD output)
9H ... 19H ... 22H: Any line from line 9 through line 22.
Note
You can insert VITC signals in two places. To insert in two places, set
both item 601 and item 602.
125
Setup Menu