Copying Clips Directly Between Xdcam Devices - Sony PDW-HD1200 Operation Manual

Copying clips directly between
XDCAM devices
In the field or another environment where the devices are
not connected to a network, you can copy (upload) clips
between XDCAM devices by connecting them directly.
The example in the following procedure shows how to
copy a clip from this unit to a PDW-HD1500. Insert discs
into both units and proceed as follows.
1
Connect this unit and the PDW-HD1500 by a network
cable.
The cable can be either a cross cable or a straight cable.
This unit
PDW-HD1500
2
Set up the two units as follows.
Item
Item M50 in the maintenance menu: DHCP
Item M59 in the maintenance menu: UPnP
3
Power both units off and on again, and wait for about
three minutes.
4
Check that the IP addresses of the two units have been
set as follows by the Auto-IP function.
Item
Item M51 in the maintenance
menu: IP ADDRESS PRESET
5
In the clip list thumbnail screen of this unit, select the
clip to copy (upload).
6
Display the Thumbnail Menu.
7
Select Upload Clips via Direct FTP, and then press the
PUSH SET(S.SEL) knob.
With , selected, the Select Transfer Type screen of
the Upload Clips via Direct FTP command appears.
8
Press the PUSH SET(S.SEL) knob.
Network cable
(not supplied)
Setting
ENABLE
ENABLE
Setting
169.254.XXX.XXX
(X: any number)
The Select Remote Host screen appears.
9
Select "Hosts Discovered via UPnP", and then press
the PUSH SET(S.SEL) knob.
The detected connection destination device (the PDW-
HD1500) appears in the Select Host Discovered via
UPnP screen.
10
Press the PUSH SET(S.SEL) knob.
Detailed information about the connection destination
device (the PDW-HD1500) appears.
11
With "Connect" selected, press the PUSH
SET(S.SEL) knob.
Transfer of the clip begins as soon as the connection is
established.
During transfer of the clip, "NETWORK!" appears in
the display of the connection destination device (the
PDW-HD1500).
When transfer of the clip completes, an Uploading
Result Report appears on the screen.
Press the PUSH SET(S.SEL) knob to return to the clip
thumbnail screen.
12
Check the copied clip in the clip thumbnail screen of
the connection destination device (the PDW-
HD1500).
Transferring Clips (Direct FTP Function)
95