Sony PDW-HD1200 Operation Manual page 54

Code (XXXX) Model
0002 PDW-1500/530/510/R1
PDW-F70/F350/F330
0200 PDW-F70/F350/F330 (Version 1.9 or
higher)
PDW-F75/F355/F335
a) PDW-HD1500/HR1/700
0300
a) PDW-HD1500/HR1/700/740 (Version 1.5
0301
or higher)
PDW-F1600/F800/HD1200/680
a)Does not appear on this unit.
• Even when these functions are used, it is not possible to
recover data from immediately before the interruption of
recording. The amount of data lost is as follows.
Quick salvage: From 2 to 4 seconds of data before the
interruption of recording.
Full salvage: From 4 to 6 seconds of data before the
interruption of recording.
(More data may be lost when the unit is subject to
vibrations, and when you switch frequently between
recording and paused.)
• You are prompted to execute a full salvage every time
you insert a disc that has not been salvaged, or power the
unit on with such as disc loaded.
• No recording is possible on discs containing clips that
have not been salvaged, although it is possible to play
back the normally recorded sections. Recording
becomes possible if you perform a quick format, but this
erases all of the original recorded content.
• If the following message appears, recording was
performed on a PDW-U1/U2 or XDS-PD1000/2000 and
may not have completed properly. Salvage the disc using
the device on which recording was performed.
"ALARM
DISC CANNOT BE SALVAGED.
PLEASE EJECT AND SALVAGE USING THE
RECORDED SET."
To restore clips with a full salvage
1
Insert the disc on which recording did not end
normally.
The message "Salvage ?" appears on the display.
To cancel the clip salvage
Press the RESET/RETURN button.
Notes
• The message "EJECT?" appears when "REC INHI"
is displayed. If the disc is write protected, eject the
disc, set the Write Inhibit tab to enable recording,
and then insert the disc again. If REC INH on
54
Recording
HOME page of the function menu is set to "ON", set
it to "OFF" (see page 43).
• This operation cannot be cancelled once it begins.
2
Press the PUSH SET(S.SEL) knob.
Processing begins and the message "Executing."
appears.
When processing finishes, a message appears to
display the results.
If the message reads "Incomplete!", the clips that
failed were lost.