Names And Functions Of Parts; Rear Panel; Connections - Sony AWS-G500HD Anycast Station Operating Instructions Manual

Names and Functions of Parts

Rear Panel

LINE
8 7 6
AC IN
4 Power supply 2 Audio outputs
connector
(~AC IN)
5 Ground terminal

Connections

The rear panel of the AWS-G500HD is the only part that differs from the
AWS-G500E. For details on the other parts, refer to the AWS-G500E Operating
Instructions.
1 Audio inputs
1VISCA
AUDIO IN
PUSH PUSH
MIC/LINE
2 1
MIC/LINE
5 4 3
OFF ON
MIX AUX PGM
R L 2 1 R L
HEADPHONES MONI INTERCOM
R L
5 1
9 6
AUDIO OUT
3 Video outputs
3 Intercom interface connector
For details on the function of each part on the rear panel, refer to the
AWS-G500E Operating Instructions.
Caution
• To maintain proper heat ventilation from the unit, be sure to keep empty slots
covered with blank panels.
• If the HD SDI IN connectors of the HD serial digital interface module are open,
a malfunction may occur in the HD SDI circuit due to noise from the nearby
equipments. When using this module, be sure to attach 75 Ω terminators to the
HD SDI IN connectors so as not to be open.
The following figure shows a sample system configuration and signal flow. For
details on how to make the connections, refer to the AWS-G500E Operating
Instructions.
After connecting each device, you must configure settings on the unit for each
input and output signal.
7 HD video interface module
connector
2 Cable clips
S VIDEO COMPOSITE
I.LINK
HD
S400
RGB COMPOSITE
PGM S VIDEO
RGB
VIOEO OUT
8 HD serial digital interface
module
Slot for optional modules
Names and Functions of Parts / Connections
VIDEO IN
S VIDEO COMPOSITE
SD
1
OFF ON OFF ON
SDI
2
3
7