Table of Contents
Advertisement
REMOVING THE TUB RING, BASKET,
OUTER TUB, AND BASKET DRIVE ASSEMBLY
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug washer or disconnect power.
2.
Remove the cabinet assembly (see page
4-16 for the procedure).
3.
Remove the agitator (see step 2 on page
4-13 for the procedure).
4.
To remove the tub ring from the outer
tub:
a) Press down on the tub ring at each of
the clips and pull the clips away from
the outer tub catches.
b) Lift the tub ring off the basket.
Press Down
Pull Out On Tub Ring Clip
TUB RING REASSEMBLY NOTE: When you
reinstall the tub ring, snap the tub ring clip with
the narrow opening onto the catch on the outer
tub first, then work around the ring to snap the
remaining clips in place.
5.
To remove the basket:
a) Use a spanner wrench and remove the
spanner nut from the drive block. Tap
the spanner wrench with a hammer to
loosen the nut while holding the basket.
Spanner Wrench
b) Press down on one side of the basket
with the heels of both hands and re-
lease the basket from the drive block,
then lift the basket off the drive shaft,
and out of the outer tub.
Basket
Outer Tub
4-18
Spanner Nut
Advertisement
Table of Contents
