Table of Contents
Advertisement
REMOVING THE SUSPENSION SYSTEM & BASE ASSEMBLY
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug washer or disconnect power.
2.
To remove the skate plate and suspen-
sion pads:
a) Remove the tub ring, basket, and outer
tub (see steps 4 through 6 on pages
4-18 through 4-20 for the procedures).
b) Lift the skate plate off the base assembly.
Skate Plate
(Shown With Lower Surface Facing Up)
c) Pry the three suspension pads off the
top of the base assembly and replace
them (see the photo at the top of the
next column).
Pry Off
Suspension Pads
3.
To remove the base assembly:
a) Remove the tub ring, basket, outer tub,
and basket drive assembly (see steps
4 through 7 on pages 4-18 through 4-20
for the procedures).
b) Remove the skate plate (see step 2b).
c) Remove two 5/16" hex-head base as-
sembly screws from the rear panel.
d) Remove the rear panel from the base
assembly.
e) If you are replacing the base assem-
bly, remove the feet, springs, etc. from
the assembly. NOTE: The new base
assembly is supplied with suspension
pads already installed.
4-21
Suspension Pads
Rear Panel Screw (1 of 2)
Base Assembly
Advertisement
Table of Contents
