Whirlpool ADVANTECH CAE2761K Installation, Operation And Service Instructions page 169

WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONL Y Y Y Y Y WHIRLPOOL COMMERCIAL ONL
WHIRLPOOL COMMERCIAL ONL WHIRLPOOL COMMERCIAL ONL
KITCHEN PRODUCTS
ALL ST ALL ST ALL ST A A A A A CK DRYERS
ALL ST ALL ST
THA THA
THA T BEGIN WITH CS
THA THA
COMPLAINT:
Income decreasing from stack dryer, or upper dryer loose
from collar assembly.
CAUSE:
The factory ½" Hex head bolts that secure the upper dryer
to the collar assembly have been removed allowing un-
authorized access to the collar.
SOLUTION:
Install Security Kit Part # 285875
Kit Contains: Screw (2)
Cotter Pin (2)
Instruction Sheet (1)
This kit is designed to prevent unauthorized access to the
collar and meter case assembly on stack dryers by
replacing the original factory ½" hex head bolts that secure
the upper dryer to the collar with the T40 Torx head bolts
and retaining clips. After the kit is installed the upper dryer
can only be removed by first gaining access to the control
panel assembly with the proper key. The contents of this
kit are factory installed on all stack dryers after serial
numbers that begin with ML50. The kit will retrofit to all
stack dryer models.
COMMERCIAL POINTERS: www.whirlpoolcorp.com/cltpsc, TECHNICAL INFORMATION, SERVICE POINTERS
LAUNDRY PRODUCTS
CK DRYERS CK DRYERS
CK DRYERS CK DRYERS , ALL MODELS
T BEGIN WITH CS T BEGIN WITH CS
T BEGIN WITH CS , CSP
T BEGIN WITH CS
REFRIGERATION PRODUCTS
, ALL MODELS , ALL MODELS
, ALL MODELS , ALL MODELS
, CSP , CSP
, CSP
, CSP
PROCEDURE:
1. Disconnect electrical supply to unit.
2. Remove the lower access panel on the upper dryer
unit by inserting a putty knife approximately 3" in from
the sides of the unit to release the spring clips
(Figure 1). Pull the top of the panel forward to release.
3. Remove the hex head bolts from the front two corners
of the upper dryer (Figure 2).
FIGURE 1
4. Replace the factory installed hex head bolts with the
T40 screws included in this kit and tighten in place.
L8178268 L8178268
L8178268 L8178268 L8178268
October 2002 October 2002 October 2002 October 2002 October 2002
FIGURE 2
(continued)