Whirlpool ADVANTECH CAE2761K Installation, Operation And Service Instructions page 137

RUNNING THE MACHINE WITHOUT
A COINSLIDE, COINDROP,
OR SMART CARD
1. Perform all steps under "Access Mode" on
page 6-8.
2. Push and release keypad position 3 (LOW).
3. The Dryer is now ready for use as if money
was used.
KEYPAD POSITIONS
HIGH
1
MEDIUM
2
LOW
3
LED DISPLAY CODES
While in the Service mode, test of the following
components can be made by manually activat-
ing the corresponding components.
CODE DESCRIPTION
Coinbox is removed.
Coinslide is pushed in.
Dryer door is closed.
Coindrop #2
receives coin.
Coindrop #1
receives coin.
Auxiliary (Smart Card)
is working properly.
SERVICE ROUTINE KEYPAD
FUNCTIONS
POSITION MODE
1 HIGH
2 MEDIUM
3 LOW
4 ON
5 OFF
6 START
ON
4
OFF
5
START
6
FUNCTION
High bias heater setting
Medium bias heater setting
Low bias heater setting
Motor
ON/OFF
Heater turns off when motor is
Heat
ON/OFF
Heater turns off when motor is
Exit Service Routine
READ LIFETIME CYCLE COUNT
1. Perform all steps under "Access Mode" on
page 6-8.
2. Lifetime Cycle Count is displayed for one
minute then it goes back showing the vend-
price. Keypad 6 (START) can be pushed to
exit this routine before the one minute ex-
pires.
LED TEST ROUTINE
1. Perform all steps under "Access Mode" on
page 6-8.
2. Push and release keypad position 5 (OFF).
3. All LEDs light and the digits show "88888".
4. Push and release keypad #6 (START) to
return to show cycle count.
5. Push keypad 6 a second time to exit the test
routine.
MANUAL OUT OF SERVICE (OFF)
This procedure allows the service person to
take the machine out of service for needed
repairs. The display shows "OFF" when set.
The display shows the vend-price when put
back into service.
1. Perform all steps under "Access Mode" on
page 6-8.
2. Push and release keypad position 5 (OFF).
All LEDs light and the digits show "88888".
3. Push and release keypad position 4 (ON).
"Out" appears on the display a short time to
show the new status.
4. Push and release keypad #6 (START) twice
to exit. The word "OFF" now replaces the
vend-price.
5. To place the machine back into service,
perform steps 1 through 3 a second time.
The word "In" appears on the LED display
for a short time to show that the new status
took effect.
6. Press keypad #6 twice to exit the service
mode. The vend-price replaces the word
"OFF," and the machine is now available for
OFF
customer use.
OFF
6-9