WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
3-Wire Method
1. Disconnect power before servicing.
2. Remove the hold-down screw and terminal
block cover.
3. Assemble a 3/4" U.L.-Listed strain relief
(U.L. marked on strain relief) into the hole
just below terminal block opening. Tighten
the strain relief screws only enough to hold
the 2 clamp sections together. Install the
power supply cord/cable through the strain
relief.
2-21