Table of Contents
Advertisement
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
BEFORE YOU START
Check location where
washer will be installed.
Proper installation is your
responsibility. Make sure
you have everything nec-
essary for correct installa-
tion.
Untape and
open washer
lid. Remove
packages and
hoses from
washer.
#T-20 Torx
Screws
On coin-operated washers,
front access to the pump area
is available by removing the
two #T-20 Torx screws and
then removing the front panel.
Important: Observe all
governing codes and
ordinances.
Washer Installation Instructions
Single washer instal-
lations require 30 cm
(12 inch) minimum
risers to provide an
air cushion and
prevent noise and
damage to valves.
A floor drain should be provided
under the bulkhead. Prefabricated
bulkheads with electrical outlets,
water supply lines, and drain facili-
ties should be used only where local
codes permit.
WARNING
Electrical Shock Hazard
Grounded electrical
outlet is required.
See "Washer Electrical
Requirements" on
page 2-3.
Level Floor:
Maximum slope
under washer is
2.5 cm (1 inch).
2-2
Hot and cold water faucets must be
within 1.2 meters (4 feet) of the back of
the washer and provide water pressure
690 kPa (10-100 PSI). A pressure reduc-
tion valve should be used in the supply
line where inlet pressure entering the
building exceeds 690 kPa (100 PSI) to
prevent damage to the washer mixing
valve.
NOTE: Water Heater—Set to
deliver 60°C to 70°C (140°F to
160°F) water to the washer.
Standpipe drain system: Needs a
5 cm (2 inch) minimum carry-away
capacity of 64.4 liters (17 gallons)
per minute. Top of standpipe must
be at least 86.4 cm (34 inches) high
and no higher than 183 cm (72 inches)
from bottom of washer.
Support: Floor must be sturdy enough
to support loaded washer weight of 143
Kg (315 pounds).
Advertisement
Table of Contents
