Table of Contents
Advertisement
5.
To remove the coindrop assembly:
a) From inside the open access panel of
the metercase, remove the screws or
hex-bolts from the back of the coindrop
assembly.
b) Position the console to its service po-
sition (see page 4-2 for the procedure).
c) Disconnect the connector(s) at P10 /
COIN 1 (& P12 / COIN 2) on the
ADVANTECH
ADVANTECH
P10 (COIN 1)
P12 (COIN 2)
d) Remove the coindrop with its wire har-
ness from the unit.
Coindrop
Assembly
control board.
Control Board
6.
To remove the coinbox switch:
a) Unlock and remove the coinbox from
the metercase.
b) Disconnect the two wires from the
coinbox switch terminals from inside
the metercase.
c) Squeeze the locking tabs on the top
and bottom of the switch body and
push the switch into the coinbox com-
partment of the metercase.
Top Locking Tab
Coinbox Switch Wires
4-8
Advertisement
Table of Contents
