Table of Contents
Advertisement
REMOVING THE AGITATOR & TRANSMISSION
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug washer or disconnect power.
2.
To remove the agitator:
a) Unsnap the agitator cap from the agi-
tator and remove it.
b) Pull off the air dome cover and remove
the rubber O-ring from inside the agita-
tor.
c) Remove the bolt from the agitator and
lift the agitator out of the washer.
Agitator Cap
Air Dome Cover
4-13
3.
To remove the transmission:
a) Tape the washer lid closed.
b) Tilt the washer back at a 45° angle, or
lay it on its back panel.
c) Unclip the two spring clips from the
pump and remove the pump from the
motor shaft (see step 4 on page 4-11).
d) Disconnect the motor wire connector
and the two motor start capacitor wires
(see step 6 on page 4-12).
e) Disconnect the harness clip from the
transmission.
Pump
Continued on the next page.
Spring Clip
(1 of 2)
Harness Clip
Transmission
Advertisement
Table of Contents
