Table of Contents
Advertisement
9. Unlock, open and remove the metercase access door, and push and hold the rocker switch located inside the meter
case. Hold down the service switch during the reprogramming process. Reprogramming takes approximately 3
minutes per unit and is complete when done is displayed.
10. Open the ADVANTECH™ Palm Application, choose select location, and pick the appropriate location. Choose
utilities, reprogram. Aim the infrared port on the Palm device into the IR port on the ADVANTECH™ console, just to
the right of the cents position on the display.
NOTE: The switch must be held at the same time the firmware is transferred. Reprograming cannot begin until the
display shows vend price. If the switch is released or the infrared beam is interrupted, the process can continue as soon
as both actions are resumed. The process does not start over if the beam is interrupted or if the switch is released.
11. To verify updated firmware load, press service switch again and release. HOT temperature LED begins blinking to
confirm that the switch was pushed. The machine's lifetime cycle count now shows on display.
NOTE: The display automatically returns to the vend price after 1 minute.
12. Press position 5, then 1, then 3. Version displayed should be 3.13
13. Select location and initialize, set serial number.
14. Select send setup, choose the proper coindrop template and select send.
15. Deposit coins to insure proper operation.
16. Select utilities, end cycle.
17. Reinstall and close and relock the metercase access door.
HOLD DOWN ROCKER SWITCH
IR Port location (white circle)
Handheld should be within 3-5" of
the console with the IR port on the
handheld in line with the IR port
on the control panel. Avoid bright
light between the ports.
Advertisement
Table of Contents
