Removing The Basket From The Tub - Whirlpool LHW0050PQ Service Manual

REMOVING THE BASKET FROM THE TUB

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the rear panel (see page 4-13).
4. Remove the two screws and starwashers
from the green/yellow ground wires and
remove them from the tub.
5. Remove the wash motor from the tub (see
page 4-16 for the procedure).
Ground Wires
Wash Motor
4-19
6. Remove the twelve 10 mm hex-head screws
from the tub.
Hex-Head
Screw (1 of 12)
7. Pull the basket assembly from the tub.
8. To remove the pulley from the basket, use a
6 mm Allen wrench, and remove the screw.
6 mm Allen
Screw
Pulley