Removing The Filter/Draining Residual Water - Whirlpool AWG 908 E Instructions For Use Manual

REMOVING THE FILTER/DRAINING
RESIDUAL WATER
We recommend that you check and clean the filter
regularly, at least two or three times a year.
Especially:
• If the appliance does not drain correctly or if single spin
cycles do not take place.
• If the "Clean filter" indication lights up:
IMPORTANT: make sure the water has cooled
before draining the appliance.
1. Switch off the appliance and unplug it.
2. Remove the plinth or open the cover (depending on
the model) by using the separator of the detergent
dispenser (fig. A / B).
3. Place a bowl beneath the filter. If the filter is located
behind the plinth (see pictures "A" e "C"), use a wide
and very flat container with a maximum height of 2 cm.
4. Open the filter but do not remove it completely.
Slowly turn the filter counterclockwise (fig. C) until the
water begins to drain out.
5. Wait until all the water has drained.
6. Now unscrew the filter completely and extract it.
7. Tilt the appliance forwards carefully to allow the water
to flow out.
8. Clean the filter and the filter chamber.
9. Check that the pump impeller can still rotate.
10. Re-insert the filter and screw it in clockwise as far as it
will go.
11. Pour about 1 l of water into the detergent dispenser to
reactivate the ecosystem". Check that the filter is
inserted properly and securely.
12. Reinstall the plinth or the cover, depending on the
model.
13. Plug in the appliance again.
14. Select a programme and start it.
A
B
C
GB 8