Removing The 2 In 1 Agitator (For Applicable Models Only) - Whirlpool WTW5057LW0 Technical Manual

6. Slide the Top Panel forward about 1/2" (13 mm).
7. Raise the Top Panel about 1/4" (6 mm). While keeping it lifted, push the
Top Panel back about 1/4" (6 mm).
8. Tilt the Top Panel up and make sure that the rear tabs are in the slots as
shown in the below figure and that it rests against a wall.
38
FOR SERVICE TECHNICIAN'S USE ONLY
Removing the 2 in 1 Agitator
(For Applicable Models Only)
1. Turn off the water supply to the washer.
2. Raise the Lid.
3. Squeeze handle.
4. Rotate the handle counterclockwise.
5. Lift the handle up to remove.