How To Attach And Remove The Wheels; Removing The Wheels; Attaching The Wheels - Otto Bock e-support Instructions For Use Manual

How to Attach and Remove the Wheels

Use the following procedure to attach and remove the wheels (removable type).

1. Removing the Wheels

Protection cap
Coupler

2. Attaching the Wheels

16
(1) Detach the battery so the power will not turn on during operation.
WARNING
Store the detached battery with the protective cap on. There is a
danger of a short-circuit when the connecting portion is exposed.
(2) Pull off the coupler of the left wheel by slightly turning the end.
Note:
Wind the removed coupler to the right wheel to prevent it from being
damaged.
(3) Lift the cam shaft lever on the left wheel. Pull the lever and remove the
wheel.
Note:
When the left wheel is removed, the remaining right wheel and the
wheelchair body are light enough to be carried as a unit. Load the
wheelchair in the car if it is not necessary to remove the other wheel.
(4) If necessary, remove the right wheel by following the same procedure.
Caution:
Remove the wheel by holding onto the battery storage so the wheel will not
spin. Depending on the circumstances, the battery and other components
may be damaged if the wheel spins when it is removed.
Insert the axle end to the frame mounting portion with the cam shaft lever of
the left wheel lifted. Then match the torque stop portion and fit the wheel in
place.
Mount the right wheel by following the same procedure.
Push in the coupler by matching the portion (white) of the coupler to the
mark on the insert inlet.