Table of Contents
Advertisement
7.3 Adjusting the drive wheels
7.3.1 Adjusting the quick-release axle
The quick-release axle should be set so the wheel is correctly engaged, with no play on the axle.
1) Hold the tip of the quick-release axle with a wrench.
2) Adjust the play by turning the nut on the end of the quick-release axle (see fig. 6, item 1) in or out.
6
7.3.2 Adjusting the handrims
INFORMATION
This section does not apply to standard wheels.
All handrims are designed for a spacing from the drive wheel of 15 mm (standard setting) and 25 mm.
1) Loosen/remove the handrim screw connection from the rim (see fig. 8).
2) Tightly screw the handrims onto the rim in narrow or wide installation position.
7
9
Invader 480S26=20000_K
Settings and assembly instructions
8
10
15
Advertisement
Table of Contents
