HP Series 6000
Hardware Installation Manual
Connecting the Cables
Note
Do not alter any jumpers on the option pins that have been
installed and preset by the factory.
1. Connect the appropriate address cable to the SCSI address cable on the drive
(see Figure 3-7). The address cables in the mass storage system are numbered
according to slot number.
2.
If
you are installing the drive in slot 2 (right rear), connect the disk status
cable (see Figure 3-5) to the SCSI status connector number 2.
3. Connect the internal SCSI cable to the drive (see Figure 3-7).
4. Connect one end of the dc power cable to the drive.
5. Connect the other end of the dc power cable to any of the unused dc power
connectors on the power supply (see Figure 1-7).
3.5-inch Hard Disk Drive Installation
3-11