Printable Area; Sc-S70600 Series/Sc-S50600 Series - Epson SC-S70600 series User Manual

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide

Printable area

SC-S70600 series/SC-S50600 series

The printable area depends on whether low or high pressure rollers are used to set the media.
When using low pressure rollers (normal printing)
The gray area in the illustration below shows the printable area. The arrow indicates the feed direction. "A" indicates
the pressure rollers on both edges when the pressure rollers have been set correctly on the media.
The left and right edges of media recognized by the printer varies as shown below according to the Media Size
Check settings.
: The printer automatically detects the left and right edges of the loaded media.
On
When media holding plates are attached, within 5 mm of the left and right edges of the media is
recognized as the media edge.
The edges of the media are not detected correctly if the media holding plates are not attached correctly.
"When the Standard Media Feeding Unit Is Installed" on page 37
U
"Using the Optional Heavy Roll Media Feeding Unit" on page 44
U
Off : 5 mm at the exterior from "A" is recognized as the edge of the media.
If the pressure rollers are not positioned correctly, printing may occur outside the left and right edges of
the media.
Ink used outside the edges of the media will stain the inside of the printer.
"Positioning of the pressure rollers and media (For SC-S70600 series and SC-S50600 series)" on
U
page 35
Basic Operations
91