Epson SC-S70600 series User Manual page 181

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Resolution Number
(dpi) of
passes
720×720 4
Vinyl
720×1440 6
All media (Including Banner/Vinyl)
720×1440 8
If banding cannot be cleared using the settings described above, select the HQ1 mode in RIP print settings. Stripe
banding and tint unevenness will less likely to occur.
If the banding cannot be cleared completely with HQ1 mode, then select HQ2 mode in RIP print settings. However,
graininess might be obvious than printing with HQ1 mode.
The print speed of HQ1/HQ2 mode becomes lower than when other print modes that use the same number of passes
are selected.
Followings are the example of the RIP print setting mode. Display of setting mode will be different depending on the
software RIP.
❏ 720x720 4pass (HQ1) / 720x720 4pass (HQ2)
❏ 720x1440 6pass (HQ1) / 720x1440 6pass (HQ2)
❏ 720x1440 8pass (HQ1) / 720x1440 8pass (HQ2)
Note:
In some cases, your software RIP does not support the above-mentioned print modes.
SC-S30600 series
Resolution Number
(dpi) of
passes
Banner
Appendix
M/W level Result
1 Stripe banding less likely
2 Tint uneveness less likely, but stripe banding more
likely
3 Stripe banding less likely
4 Tint uneveness less likely, but stripe banding more
likely
0 Stripe banding less likely
1 Tint uneveness less likely, but stripe banding more
likely
2 Stripe banding less likely
3 Tint uneveness less likely
M/W level Result
181
Recommendation
✓
✓
✓
Recommendation