Epson SC-S70600 series User Manual page 45

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
C
Loosen the left and right roll holder fixing screws
sufficiently and separate the roll holders so that
the distance between them is wider than the
media.
c
Important:
If the right holder handle shaft is not visible,
rotate the handle forward until it stops. The
media can not be properly loaded if the handle
shaft is not visible.
D
Temporarily place media on the lifter oriented
according to how it is rolled (see below).
Printable Side Out
Printable Side In
E
Align the left and right edges of the media with
the set positions according to the media width.
Recommended positioning by media width
Basic Operations
"Positioning of the pressure rollers and
U
media (For SC-S70600 series and SC-S50600
series)" on page 35
Note:
If the label with black squares is not in place, affix
the label as described in the Setup Guide.
U Setup Guide
F
Align the media and the roll holders.
Raise or lower the lifter until the media roll core is
level with the roll holders.
45