Epson SC-S70600 series User Manual page 95

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
* When Media Size Check is set to Off, this is 1,626 mm (64 inches) regardless of the width of the loaded media.
A D
to indicates the margins on all four sides. See the following for more details.
Margin Explanation
Position
*1 This can be configured in RIP. To maintain media feeding accuracy, if the settings are less
A
Bottom
than 5 mm or more than 17 mm, the settings are switched to 5 mm and 17 mm
respectively.
*1
B This can be configured in RIP. Differs by the length the media was pulled when the media is
Top
loaded. For continuous printing, although the margins set in RIP are added, to maintain
media feeding accuracy, if the setting is less than 5 mm the setting is switched to 5 mm.
*2, *3 The value selected for Side Margin(Left) in the printer's setup menu. The default setting is
C
Left
5 mm.
D *2, *3 The total of the values selected for Print Start Position and Side Margin(Right) in the
Right
printer's setup menu. The default setting for Print Start Position is 0 mm and Side
Margin(Right) is 5 mm.
*1 The configured margin and the actual print results may differ depending on the RIP being used. Contact the RIP
manufacturer for more information.
*2 This may be available in the RIP depending on the software RIP being used. Contact the RIP manufacturer for
more information.
Basic Operations
95
Available
Setting
Range
5 to 17 mm
5 mm or more
3 to 25 mm
3 to 825 mm