Epson SC-S70600 series User Manual page 158

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Messages
Media Sensor Error
Loaded media or print out has a problem.
Refer to documentation for details.
Pressure Roller Error
Pressure rollers are positioned incorrectly.
Release media loading lever and
reposition rollers.
Ink Layering Error
Pressure rollers are positioned incorrectly.
Reposition rolllers.
Roll Type Error
Release and then reset the media loading
lever, then match Roll Type setting to
actual media.
Problem Solver
What to do
Press the W button to clear the message from the display.
The auto menu of Auto Media Adjust, Auto Nozzle Check, and Media Adjust of
the media settings are not available in the following media setting or conditions.
❏
Transparent or colored media, or tracing paper is used.
❏
Platen Gap is set to 2.5 in the media settings.
❏
The printer is used in a place that is exposed to direct sunlight or interference
from other ambient light sources.
In these cases, execute the manual menu.
When executing Auto Media Adjust or Media Adjust: U
page 86
When executing Auto Nozzle Check: U
page 128
If the printer is exposed to interference from ambient light sources, shade the
printer from these sources and perform the function again; it may succeed. When
the function has failed after shading the printer, execute the manual menu.
If this error is displayed when executing under conditions other than those listed
above, when executing Auto Media Adjust, or the auto menu of Media Adjust,
adjustment pattern printing may fail due to nozzle clogging. Perform head
cleaning, and execute them again.
"Head Cleaning" on page 129
U
If this error is displayed under conditions other than those listed above, confirm
that the currently loaded media match usage conditions of the printer.
"Supported Media" on page 176
U
One of the following has occurred. Reposition the rollers as described in "Printable
Area".
❏
None of the rollers is positioned inside the bounds of the black labels.
❏
Only one of the rollers is positioned inside the bounds of the black labels.
❏
The rollers at the edges of the media are not the same type.
(A high pressure roller is at one edge, a low pressure roller at the other.)
❏
On is selected for Media Size Check in the printer settings menu and a roller
is positioned in a black label that is not over the media.
❏
Two rollers are positioned inside the bounds of the same black label.
"Printable area" on page 91
U
You are using the low pressure rollers. Use the high pressure rollers for ink layering.
❏
Does the Roll Type specified at media loading match the actual roll type?
Raise the media loading lever to resolve the error. Lower the media loading
lever again, and follow the on-screen instructions of the printer to correctly
specify the Roll Type.
158
"Media Adjust" on
"Printing nozzle check patterns" on