Media Adjust - Epson SC-S70600 series User Manual

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
C
Choose a value.
Heater Temperature
The temperatures for the pre-, platen, and after
heaters can each be adjusted separately.
Note:
❏ The standard heater temperatures are as
follows.
❏
Set the heaters to the temperatures
recommended in the documentation
provided with the media, if available.
❏
Raise the temperature if the print results are
blurred or smudged or the ink clots. Note,
however, that raising the temperature too
high can cause the media to shrink, wrinkle,
or deteriorate.
❏ The time needed for the heaters to reach the
specified temperatures varies with the ambient
temperature.
(1) Use the r/l buttons to select a heater. From
left, the options are pre-heater, platen heater,
and after heater.
(2) After selecting the desired heater, use the d/u
buttons to choose the temperature.
(3) After making the setting, press the Z button.
Additional Dryer
Note:
❏ This menu is displayed only when the optional
additional print drying system (supplied with
the SC-S50600 series; optional with other
models) is installed.
❏ The default setting is set to On, and the drying
fan turns on automatically when printing
starts.
(1) Use the d/u buttons to select On or Off.
(2) Press the Z button.
D
Press the y button twice to return to the
customize settings menu.
Basic Operations

Media Adjust

This menu is used to adjust media when Auto Media
Adjust cannot be used or when reconfiguring media
settings is required due to a change made in printing
conditions after saving the media settings. In this menu,
perform Feed Adjustment and Head Alignment
individually.
Media adjustment when Auto Media Adjust cannot
be used
When you cannot adjust media using Auto Media
Adjust or when banding or graininess is detected in
printing results even after Auto Media Adjust has been
performed, select Feed Adjustment - Manual and
Head Alignment - Standard (Manual) to take
appropriate actions.
When changing printing conditions after saving
media settings
After saving media settings, select Feed Adjustment -
Auto in this menu when:
❏ The Media Tension or Media Suction setting has
been changed in Advanced Settings;
❏ Counterweights have been attached to or detached
from the tensioner;
❏ The standard media unit and the optional heavy roll
media system have been switched; or
❏ The configuration of pressure rollers have been
changed (SC-S70600 series, SC-S50600 series).
When Platen Gap has been changed, select Head
Alignment - Standard (Auto) in this menu. However, if
the setting value is changed to 2.5, auto adjustment
becomes unavailable. Perform Standard (Manual).
Change the setting values of the following items before
executing this menu.
❏ Platen Gap
❏ Advanced Settings
"Customize Settings" on page 145
U
Feed Adjustment
This menu is used when banding (horizontal banding,
tint unevenness, or stripes) is detected in printing
results.
86