Epson SC-S70600 series User Manual page 39

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
F
Raise the lift lever on the left side of the printer to
lift the media into position, then firmly insert the
roll holder.
Note:
If the media roll has an outer diameter that is less
than 140 mm, lift it manually, and load it to the roll
holder. The roll core will not reach the holder when
raised using the lift lever.
G
Tighten the roll holder screw until the screw no
longer turns to fix the roll holder in place.
Basic Operations
H
Raise the lift lever on the right side of the printer
to lift the media into position, then firmly insert
the roll holder.
Note:
If the media roll has an outer diameter that is less
than 140 mm, lift it manually, and load it to the roll
holder.
I
To ensure the roll holder is inserted into the roll
core sufficiently, push the center section on the
side of the roll holder towards the roll end twice.
39